Well, I had to create some way of holding the ignition mount up on the underside of the bucket. I decided to weld a ring into the bucket that would have holes aligned to holes I tapped into the mount. I drilled out a 3/4" hole into the center of a washer. Then, I drilled clearance holes for 8-32 screws on the washer. I know; it should be metric, but I didn't have the list of drillbits associated with metric taps. I center-punched these holes onto the ignition mount from Rocky Point. I then drilled and tapped the holes on the mount. I tack welded the washer on the underside of the bucket using a MIG setup. It was pretty ugly. So, I finished the job with JB Weld. I still need to grind down the tack welds.POR-15 to reline the tank before sanding and painting it. I've had good luck with the POR products on two other tanks. The bike has been repainted already as indicated by the tape pinstripes (ugh). I plan to paint and pinstripe it myself. I'll post more on the changes as they come.